NI PCIe-8255R User Manual
2
ni.com
Optional Equipment
National Instruments offers a variety of products for use with the
NI 8255R, including the following:
•
Digital I/O cable and horizontal DIN rail terminal block
(part number 778790-01)
1
•
Digital I/O cable and vertical DIN rail terminal block
(part number 778791-01)
•
NI Vision I/O Terminal Block and Prototyping Accessory
(part number 779166-01)
•
24 V, 50 W power supply (part number 778794-01) for powering
isolated outputs
•
Sony IEEE 1394a high resolution monochrome camera
(part number 778849-01)
•
Basler IEEE 1394a standard resolution monochrome camera
(part number 778785-01)
•
LED ringlight and constant current source (part number 778787-01)
•
12 mm fixed focal length lens (part number 778789-01)
For specific information about these products, refer to the
National Instruments catalog, visit
ni.com
, or contact the National
Instruments office nearest you.
Safety Information
Caution
The following paragraphs contain important safety information you
must
follow
when installing and operating the device.
Do
not
operate the device in a manner not specified in the documentation.
Misuse of the device may result in a hazard and may compromise the safety
protection built into the device. If the device is damaged, turn it off and do
not
use it until service-trained personnel can check its safety. If necessary,
return the device to National Instruments for repair.
Keep away from live circuits. Do
not
remove equipment covers or shields
unless you are trained to do so. If signal wires are connected to the device,
hazardous voltages can exist even when the equipment is turned off. To
avoid a shock hazard, do
not
perform procedures involving cover or shield
removal unless you are qualified to do so. Disconnect all field power prior
to removing covers or shields.
1
When using this accessory with the NI 8255R, three of the digital I/O signals on the device are not accessible. Refer to the
Connectors
section of the
NI PCIe-8255R User Manual
for more information.
