© National Instruments
|
1-17
Using the cDAQ Chassis on a Desktop
Complete the following steps to install the NI desktop mount kit, part number 781988-01, on the
cDAQ chassis.
9.
Align one of the end brackets with the mounting hole at one of the ends of the chassis, as
shown in Figure 1-11.
Figure 1-11.
Connecting the End Brackets to the Chassis
10. Use a number 2 Phillips screwdriver to tighten the captive screw on the end bracket.
11. Repeat steps 9 and 10 to attach the other end bracket to the other end of the chassis.
Note
To achieve the highest accuracy when mounting the chassis in the desktop kit,
NI recommends that you operate the chassis with the modules rotated forward, as
shown in Figure 1-11. Visit
ni.com/info
and enter the Info Code
cdaqmounting
for more information about mounting and accuracy.
1
Mounting Holes
2
Captive Screw
NI c
DA
Q-
913
9
NI
Co
mp
actD
AQ
2
1