1. Loosen the captive screw and remove the top cover.
2. Prepare the screw-terminal wire by stripping the insulation.
Refer to the Specifications section for more information on
screw terminal wiring.
3. Insert the stripped end of the wire fully into the appropriate
terminal. Make sure that no exposed wire extends past the
screw terminal.
4. Secure the connecting by tightening the screw for the
terminal.
Refer to the Specifications section for more information on
screw terminal torque.
5. Route the wire to the NI 9935 opening.
6. Remove slack in the NI 9935 wiring and secure the wires or
cable by threading a zip tie through the two strain relief holes
on the NI 9935 opening.
7. Reinstall the top cover of the NI 9935 and tighten the captive
screw.
NI 9935 Getting Started Guide and Specifications
|
© National Instruments
|
5
