4
|
ni.com
|
NI 9924 User Guide and Specifications
Connecting the Signals
To wire the NI 9924, complete the following steps while referring
to Figure 2.
Note
When using shielded wires or cable, use the
SH terminal on the NI 9924 to terminate the shields.
1. Loosen the captive screws and remove the top cover.
2. Prepare the screw-terminal wire by stripping the insulation.
Refer to the
section for more information on
screw-terminal wiring.
3. Insert the stripped end of the wire fully into the appropriate
terminal. Make sure no exposed wire extends past the screw
terminal.
4. Secure the connection by tightening the screw for the terminal.
Refer to the
section for information on
screw-terminal torque.
5. Route the wire to the NI 9924 opening.
6. Remove slack in the NI 9924 wiring and secure the wires or
cable by threading a zip tie through the two strain relief holes
on the NI 9924 opening.
