1. Loosen the captive screws on the TB-9214 and remove the
top cover and foam pad.
2. Insert the stripped end of the wire fully into the appropriate
terminal and tighten the screw for the terminal. Make sure no
exposed wire extends past the screw terminal.
3. Route the wire through the TB-9214 opening, remove slack
from the wiring, and secure the wires using a zip tie.
4. Replace the foam pad in the TB-9214 opening, reinstall the
top cover, and tighten the captive screws.
Installing the TB-9214
What to Do
1. Connect the TB-9214 to the NI 9214 front connector.
2. Tighten the jackscrews to a maximum torque of 0.4 N · m
(3.6 lb · in.). Do not overtighten the jackscrews.
NI 9214 Getting Started Guide
|
© National Instruments
|
17