Chapter 2
Installation and Configuration
2-36
ni.com
3.
Align the notch in the center of the DDR DIMM module with the key
on the DIMM slot. Insert the module vertically into the slot and push
it in until the pins are fully inserted, as shown in the following figure.
4.
When the module is fully inserted, the plastic clip at each side of the
slot automatically closes, as shown in the following figure.
5.
Replace the NI 8350 cover by sliding the cover forward. Make sure the
safety lock fits firmly.
Removing DDR Modules
Complete the following steps to remove DDR modules:
1.
Open the plastic clips on both sides of the module.
2.
Remove the module from the slot.
1
Notch
2
Key
1
2
