c) In the
Configure Open FPGA VI Reference
dialog box, click the
Browse
button
next to the
Bitfile
button.
d) In the
Select Bitfile
dialog box that opens, select the bitfile for your desired target.
The bitfile name is based on the adapter module, example type, and FPGA module.
e) Click the
Select
button.
f)
Click
OK
in the
Configure Open FPGA VI Reference
dialog box.
g) Save the VI.
7. On the front panel, in the
RIO Resource
pull-down menu, select an NI 5772R resource
that corresponds with the target configured in step 6.
8. Select
AI 0
in the
AI Channel
control.
9. Set the
Trigger Level (V)
and the
Record Size
controls to the desired value.
10. In the
Trigger Type
box, you can select either
Software
or
Data Edge
. If you select
Software
, the VI acquires data every time you click the
Software Trigger
front panel
button. If you select
Data Edge
, the VI acquires data every time an edge occurs.
11. Click the
Run
button to run the VI.
12. Click the
Software Trigger
button if you selected
Software
in the
Trigger Type
control.
The VI acquires data and displays the captured waveform on the
Acquired Waveform
graph as shown in the figure below.
13. Click the
STOP
button to stop the VI.
14. Close the VI.
Figure 6.
NI 5772 - Getting Started (Host) VI Front Panel
Creating a LabVIEW Project and Running a VI on an
FPGA Target
This section explains how to set up your target and create an FPGA VI and host VI for data
communication. This section focuses on proper project configuration, proper CLIP
NI 5772R User Manual and Specifications
| © National Instruments | 13
Summary of Contents for NI 5772R
Page 1: ...NI 5772...