National Instruments NI 5741, Getting Started Manual

Page: 3 / 17

Installing the NI FlexRIO Devices............................................................................................6
Installing the NI FlexRIO Adapter Module...................................................................... 6
Connecting Cables.................................................................................................................... 7
Removing the Adapter Module.................................................................................................8
Disabling the Adapter Module in LabVIEW FPGA.........................................................8
Uninstalling the Module....................................................................................................8
Installing Accessories............................................................................................................... 8
Appendix A: NI 5741 Features................................................................................................. 9
Front Panel and Connector Pinouts...................................................................................9
Block Diagrams...............................................................................................................11
Appendix B: Interfacing with the NI 5741............................................................................. 12
Component-Level Intellectual Property (CLIP)............................................................. 12
Clocking.......................................................................................................................... 15
Where to Go Next................................................................................................................... 15
Worldwide Support and Services............................................................................................ 16
Electromagnetic Compatibility Guidelines
This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC) stated in the product specifications. These requirements
and limits are designed to provide reasonable protection against harmful interference when the
product is operated in the intended operational electromagnetic environment.
This product is intended for use in industrial locations. However, harmful interference may
occur in some installations, when the product is connected to a peripheral device or test object,
or if the product is used in residential or commercial areas. To minimize interference with
radio and television reception and prevent unacceptable performance degradation, install and
use this product in strict accordance with the instructions in the product documentation.
Furthermore, any modifications to the product not expressly approved by National Instruments
could void your authority to operate it under your local regulatory rules.
Caution
To ensure the specified EMC performance, operate this product only with
shielded cables and accessories.
Note
To ensure the specified EMC performance, the length of all I/O cables must
be no longer than 30 m (100 ft).
How to Use Your FlexRIO Documentation
Refer to the following flowchart for information about how to use FlexRIO documentation.
2 | ni.com | NI 5741 Getting Started Guide