![background image](http://html.mh-extra.com/html/national-instruments/mydaq-195509d-01l/mydaq-195509d-01l_user-manual-and-specifications_709607008.webp)
NI myDAQ User Guide and Specifications
8
ni.com
NI myDAQ and NI Multisim
You can use NI ELVISmx instruments in NI Multisim to simulate a circuit,
measure the real signals with NI myDAQ, and compare simulated and
acquired data. To see step-by-step instructions for using NI ELVISmx
instruments in NI Multisim, refer to
Using NI ELVISmx in NI Multisim
help
file, installed with NI ELVISmx. To access this help file, go to
Start»
All Programs»National Instruments»NI ELVISmx for NI ELVIS &
NI myDAQ»Using NI ELVISmx in NI Multisim
.
Getting Started
Caution
For EMC compliance, the USB cable must be less than 2.0 m (6.6 ft) in length.
Also, wires attached to the MIO screw terminal connector must be limited to 30.0 cm
(11.8 in.) in length.
Getting started with NI myDAQ is a simple process, but it is important to
ensure that you install the right components in the correct order. To get
started with your NI myDAQ, complete the following steps:
1.
Install the NI myDAQ Software Suite from the DVD shipped with your
device.
The NI myDAQ Software Suite installs application software
(NI LabVIEW, NI Multisim) first, and then installs the NI ELVISmx
driver software.
Note
If you are not installing software from the NI myDAQ Software Suite media, make
sure to install all application software before installing the driver software.
2.
Connect the cable from the computer Hi-Speed USB port to the USB
port on the device.
The computer will recognize the NI myDAQ and the NI ELVISmx
Instrument Launcher appears. You can also manually open
NI ELVISmx Instrument Launcher by selecting
Start»All Programs»
National Instruments»NI ELVISmx for NI ELVIS & NI myDAQ»
NI ELVISmx Instrument Launcher
.