Chapter 2
Hardware Installation
Fiber-Optic MXI-Express x4 for PXI Express User Manual
2-4
ni.com
4.
Make sure the injector/ejector handle is in its downward position.
Be sure to remove all connector packaging and protective caps from
retaining screws on the module. Align the NI PXIe-8375 with the card
guides on the top and bottom of the system controller slot.
Caution
Do
not
raise the injector/ejector handle as you insert the NI PXIe-8375. It will not
insert properly unless the handle is in its downward position so that it does not interfere
with the injector/ejector rail on the chassis, as shown in Figure 2-2.
5.
Hold the handle as you slowly slide the module into the chassis until
the handle catches on the injector/ejector rail.
6.
Raise the injector/ejector handle until the module firmly seats into the
backplane receptacle connectors. The front panel of the NI PXIe-8375
should be even with the front panel of the chassis.
Note
LEDs on the back side of the NI PXIe-8375 card will light, indicating the presence
of 5V auxiliary power.
7.
Tighten the bracket-retaining screws on the top and bottom of the front
panel to secure the NI PXIe-8375 to the chassis.
8.
Replace or close any doors or covers to the chassis.
