Index
©
National Instruments Corporation
I-3
J
jumpers
W1
input mode control for VIDEO0
input, 2-6 to 2-7
required for BNC input (note), 4-1
W3, external CLK and synchronization
input mode, 2-7
L
LabVIEW software, 1-3
line count
definition, 3-6
programmable pixel and line count, 3-7
line region, active, 3-6
lock mode, external, 3-9
lookup table, 8-bit ADC and LUT, 3-3
M
mapping circuitry, 3-4
motion control, integrating with, 1-6
N
National Instruments application software,
1-3 to 1-6
National Instruments Web support, C-1 to C-2
NI-IMAQ driver software, 1-4
NVRAM, 3-5
P
parts locator diagram
PCI-1408, 2-5
PXI-1408, 2-6
PCI interface
overview, 3-5
specifications, A-3
PCI/PXI-1408 devices. See also hardware
overview.
features and overview, 1-1 to 1-2
optional equipment, 2-2
requirements for getting started, 2-1 to 2-2
setting up IMAQ system, 2-2 to 2-3
software programming choices, 1-3 to 1-6
National Instruments IMAQ
Vision, 1-5
National Instruments IMAQ Vision
Builder, 1-5
NI-IMAQ driver software, 1-4
unpacking, 2-4
PCLK
acquisition window control, 3-6
genlock and synchronization
circuitry, 3-3
internal pixel clock specifications, A-3
PCLK, HSYNC, VSYNC mux, 3-3
PCLKIN± signal (table), 4-2
physical specifications, A-4
picture aspect ratio, 3-7
pin assignments
BNC connector (figure), 4-1
I/O connector (figure), 4-2
pixel aspect ratio, defined, 3-7
pixel aspect ratio circuitry, 3-3
pixel clock. See PCLK.
pixels
active pixel region, 3-6
horizontal count, 3-6
line count, 3-6
programmable pixel and line count, 3-7
PLL circuitry, 3-3
power requirements, A-3
programmable gain and offset circuitry, 3-2
