IMAQ D100DAL Cable Installation Guide
4
www.natinst.com
Follow these steps to connect an IMAQ D100DAL cable to a camera with
separate control connector and power connector receptacles, as illustrated
in Figure 2.
1.
Insert the 100-pin SCSI-type connector end of the IMAQ D100DAL
cable into the external 100-pin SCSI-type receptacle of your IMAQ
device, ensuring correct polarity. Tighten the thumbscrews as
necessary.
2.
Insert the OS1/2 camera connector of the IMAQ D100DAL cable into
your camera’s corresponding receptacle, ensuring correct polarity.
3.
Insert the OS3/4 camera connector of the IMAQ D100DAL cable into
your camera’s corresponding receptacle, ensuring correct polarity.
Note
Some DALSA cameras have only an OS1/2 receptacle. With such cameras, you do
not need to connect anything to the OS3/4 connector.
4.
Insert the IMAQ D100DAL control connector into the camera’s
corresponding receptacle, ensuring correct polarity.
Figure 2.
IMAQ D100DAL Cable Without Camera Power Supply Connector
1
Trigger Connector
2
IMAQ D2504 Cable
3
OS1/2 Connector
4
OS3/4 Connector
5
Control Connector
6
DALSA Camera
7
Power Connector
8
IMAQ D100DAL cable
9
SCSI-Type Connector
10 IMAQ Device
10
9
8
1
6
2
To Triggers
3
4
5
7
