![background image](http://html1.mh-extra.com/html/national-instruments/imaq-d100dal/imaq-d100dal_installation-manual_3398881002.webp)
IMAQ D100DAL Cable Installation Guide
2
www.natinst.com
Installation
Follow these steps to connect an IMAQ D100DAL cable to a camera with
a combined control/power connector receptacle, as illustrated in Figure 1.
1.
Insert the 100-pin SCSI-type connector end of the IMAQ D100DAL
cable into the external 100-pin SCSI-type receptacle of your IMAQ
device, ensuring correct polarity. Tighten the thumbscrews as
necessary.
2.
Depending on your camera, insert the OS1 or OS1/2 camera connector
of the IMAQ D100DAL cable into your camera’s corresponding
receptacle, ensuring correct polarity.
3.
Insert the OS2 or OS3/4 camera connector of the IMAQ D100DAL
cable into your camera’s corresponding receptacle, ensuring correct
polarity.
Note
Some DALSA cameras have only an OS1 or OS1/2 receptacle. With such cameras,
you do not need to connect anything to the OS2 or OS3/4 connector.
4.
Insert the IMAQ D100DAL control/power connector into the camera’s
corresponding receptacle, ensuring correct polarity.
5.
Insert the IMAQ D100DAL cable’s power supply connector into the
camera’s external power supply receptacle.