![background image](http://html1.mh-extra.com/html/national-instruments/gpib-usb-series/gpib-usb-series_hardware-manual_3531097035.webp)
Chapter 1
GPIB Hardware
1-28
ni.com
Ethernet Connector LEDs
The Ethernet connector LEDs on the back panel, shown in Figure 1-12,
indicate your Ethernet connection status.
Figure 1-12.
Ethernet Connector LEDs
The
10/100/1000
LED indicates your Ethernet connection speed.
•
Yellow
—Indicates your network connection is 1000 Mbit/s.
•
Green
—Indicates your network connection is 100 Mbit/s.
•
Off
—Indicates your network connection is 10 Mbit/s, or the Ethernet
is not connected if the
ACT/LINK
LED also is off.
The
ACT/LINK
LED indicates network activity.
•
Steady green
—Indicates you have a network link, but no network
activity is detected.
•
Flickering green
—Indicates you have a network link and network
activity is detected.
•
Off
—Indicates you do not have a network link.
Software Recognition
Use the GPIB Ethernet Wizard to add the GPIB-ENET/1000 to your
system. Launch the GPIB Ethernet Wizard from
Start»Programs»
National Instruments»NI-488.2
.
(Windows 8)
Click
NI Launcher
and
select GPIB Ethernet Wizard. Accept the GPIB-ENET/1000 default
configuration settings or change them while running the wizard.
Ethernet Configuration
The GPIB-ENET/1000 uses a Web page for device configuration. If your
network uses DHCP, the network configuration is performed automatically
at startup, and you should not need the GPIB-ENET/1000 Configuration
Web page unless you need to modify the hostname or update the firmware.
10/100/1000 ACT/LINK