© National Instruments Corporation
3-1
GPIB-130 User Manual
Chapter 3
Configuration and Operation
This chapter describes how to configure and operate a GPIB-130 system.
Operating Modes
The GPIB-130 has two operating modes: Unbuffered mode and Buffered mode. The operating
mode determines how data is transmitted across the extension. Both units in the extension
system must be set to the same mode.
Unbuffered Mode
In Unbuffered mode, each data byte is transmitted using the GPIB double interlocked
handshaking protocol. For long data streams, transfers using Unbuffered mode are slower than
transfers using Buffered mode. However, the GPIB extension is transparent in Unbuffered
mode.
Buffered Mode
In Buffered mode, the GPIB-130 uses FIFOs to buffer data between the remote and local units.
For long data streams, you can obtain a much higher data throughput with Buffered mode than
with Unbuffered mode.
Consider the following situation: a GPIB device on the local side of the extension is addressed to
talk; another device on the remote side is addressed to listen. When the talking device sources
data bytes, the GPIB-130s accept the data bytes and store them in a FIFO. At the same time, the
GPIB-130s read data from the FIFO and source data bytes to the Listener. Whenever the FIFO
contains data, the number of bytes sourced by the Talker differs from the number of bytes
accepted by the Listener. A few applications may not operate properly in Buffered mode.
GPIB command bytes are not stored in the FIFOs; they are transmitted using the GPIB double
interlocked handshaking protocol.
In most applications, the GPIB-130s should be configured in Buffered mode.