![background image](http://html1.mh-extra.com/html/national-instruments/fd-11601/fd-11601_user-manual_3373502036.webp)
Figure 27. FieldDAQ Installation Supply List
2
1
3
4
5
6
NI-DAQmx
7
9
8
10
11
1. Host Computer
2. Supported Real-Time Controller
3. LabVIEW Software, if not already installed
4. LabVIEW Real-Time Module, if not already
installed
5. Driver for the Real-Time Controller, if not already
installed
6. NI-DAQmx Driver, if not already installed
7. FieldDAQ Device
8. 5-pin L-coded M12 Power Input Cable
9. 8-pin X-coded M12 Ethernet Cable
10. External Power Supply
11. 5-pin A-coded M12 I/O Cables and Accessories
Note
LabVIEW Real-Time 2017 or later required to use the FieldDAQ
synchronization features.
Note
You can either use a shielded straight-through Ethernet cable or an Ethernet
crossover cable to connect the FieldDAQ device directly to your computer.
Complete the following steps.
1.
Install the LabVIEW, LabVIEW Real-Time Module, and controller driver software on the
host machine as instructed in the getting started or quick start document for the Real-
Time controller.
2.
Install NI-DAQmx on the host machine if the driver was not installed in step 1.
a.
. Complete the instructions.
b.
Register your NI hardware online at
when prompted.
c.
Download NI-DAQmx to the target using MAX. Refer to the
MAX Remote Systems
Help
by selecting
Help
»
Help Topics
»
Remote Systems
in MAX.
If you have problems installing your software, go to
3.
Set up your Real-Time controller hardware and install software to it as instructed in the
getting started or quick start document for the Real-Time controller.
36
|
ni.com
|
FD-11601 User Guide