Figure 3. Connecting the cRIO-9805 to a Controller Power Connector
cRIO-904
1.
Power off the power supply connected to the CompactRIO controller.
2.
Remove the power connector from the CompactRIO controller.
3.
Use a two-wire ferrule to insert the power supply wires and module power wires into the
CompactRIO controller power connector terminals.
4.
Tighten the terminal screws on the power connector to 0.20 N · m to 0.25 N · m
(1.8 lb · in to 2.2 lb · in) of torque.
5.
Install the power connector on the front panel of the CompactRIO controller.
6.
Tighten the power connector screw flanges to 0.20 N · m to 0.25 N · m (1.8 lb · in to
2.2 lb · in) of torque.
7.
Connect a ferrule to the other end of the power wires.
8.
Push the ferruled wires directly into the power connector terminals on the cRIO-9805.
9.
Power on the power supply.
10. Verify the cRIO-9805 Power/Status LED is on.
Disconnecting Power from the cRIO-9805
1.
Power off the power supply connected to the cRIO-9805.
2.
Use a small flathead screwdriver or similar tool to press the white release button on the
power connector.
3.
Remove the ferruled wire from the power connector.
4.
Repeat steps 2 and 3 to remove the second ferruled wire from the power connector.
6
|
ni.com
|
cRIO-9805 Getting Started Guide
