5.
Click
STOP
to conclude the test.
Removing Modules
Removing the ATCA-3671 Module
1.
Disconnect all cables from the ATCA-3671 module.
2.
Loosen the four captive screws on the front panel of the ATCA-3671 module.
3.
Push up on the latch and rotate the ejector handle away from the module to unseat the
backplane connectors to open the ejector handles.
4.
Caution
Use two hands while removing the module to ensure that the module
is not dropped once it is free of the chassis.
Carefully remove the ATCA-3671 module from the chassis.
Removing the RTM
1.
Disconnect all cables from the RTM.
2.
Loosen the four captive screws on the back panel of the RTM.
3.
Use the ejector handles to unseat the RTM from the chassis.
4.
Caution
Use two hands while removing the module to ensure that the module
is not dropped once it is free of the chassis.
Carefully remove the RTM from the chassis.
Removing the ATCA I/O Module
Complete the following steps to remove an ATCA I/O module from the ATCA-3671.
1.
Disconnect all cables to the ATCA I/O module.
2.
Power off the ATCA-3671.
3.
Unscrew the ATCA I/O module.
4.
Remove the ATCA I/O module.
Front Panels and Connectors
ATCA-3671 Front Panel
Figure 13. ATCA-3671 Front Panel
ESD
SENSITIVE
ATCA-3671
FPGA Module for ATCA
AIO A
AIO B
AIO C
AIO D
JC OUT A
CLK IN/OUT A
JC OUT B
CLK IN/OUT B
GPIO B
AIO CLK
JTAG
SYNC A
GPIO C
MGT REF
SYNC B
GPIO D
GPIO A
JC OUT C
CLK IN/OUT C
JC OUT D
CLK IN/OUT D
1Gb ETH
ATCA-3671 Getting Started Guide
|
© National Instruments
|
19