Index
AT-MIO-16 User Manual
Index-4
© National Instruments Corporation
general-purpose connections, 3-19 to 3-25
counter block diagram, 3-20
event-counting application with external
switch gating (illustration), 3-22
frequency measurement, 3-22 to 3-23
frequency measurement application
(illustration), 3-23
GATE, SOURCE, and OUT signals,
3-19 to 3-25
input and output ratings, 3-23 to 3-24
time-lapse measurement, 3-22
timing I/O circuitry block diagram, 3-19
timing requirements (illustration), 3-24
timing signals, 3-19 to 3-25
ground-referenced signal sources
definition and requirements, 3-6
differential connections, 3-8
recommended configurations (table), 3-7
single-ended connections, 3-11
H
hardware installation, 2-17 to 2-18
I
input configurations
common mode signal rejection, 3-11
to 3-12
differential input
floating signal sources, 3-8 to 3-9
general considerations, 3-7
ground-referenced signal
sources, 3-8
recommended configurations for ground-
referenced and floating signal
sources (table), 3-7
single-ended connections
floating signal (RSE) sources, 3-10
general considerations, 3-10
grounded signal (NRSE)
sources, 3-11
input polarity, configuring. See polarity
configuration.
installation. See also configuration.
hardware installation, 2-17 to 2-18
unpacking the AT-MIO-16, 1-5
instrumentation amplifier, 3-5 to 3-6
internal reference selection (table), 2-14
interrupts
configuration, 2-5
factory default settings (table), 2-1
jumper settings (table), 2-5
I/O connector pin assignments, 3-1 to 3-2
signal description, 3-3 to 3-4
J
jumper settings
analog input
DIFF (differential) input
configuration, 2-9
input polarity and range (table), 2-11
NRSE input (16 channels), 2-10
RSE input (16 channels), 2-9 to 2-10
analog I/O jumper settings quick
reference (table), 2-6 to 2-7
analog output
data mode settings (table), 2-15
polarity settings (table), 2-15
AT bus interface settings, 2-1
factory default settings (table), 2-1
base I/O address, 2-3
example settings (illustration), 2-3
switch settings with base I/O address
and address space (table), 2-4
bipolar output selection (table), 2-15
DMA selection, 2-4 to 2-5
external reference selection (table), 2-14
input polarity and input range
(table), 2-11
internal reference factory setting
(table), 2-14
interrupt selection, 2-5
overview, 2-1
RTSI bus clock selection, 2-17
straight binary mode (table), 2-15
two's complement mode (table), 2-15
unipolar output selection (table), 2-15
L
LabVIEW software, 1-2 to 1-3
LabWindows software, 1-2 to 1-3