Components and Assembly
POWER TOOL ASSEMBLY
This machine is currently only compatible with the HILTI TE1000 and TE1500 jackhammers. Using a 17 mm wrench and an Allen key, complete
the following steps to assemble the power tool to the machine:
1. Unscrew lower tool holder (Figure 1) and upper tool holder (Figures 2-4).
8
FIG. 1
402616_TROLLEY_RevE
2. Re-attach top half of the upper tool holder so that the nuts and upper half resemble Figure 5.
3. Place power tool on the holder (Figure 6); re-place top half of the lower tool holder and screw it into place (Figure 7). Note: Notched side
of the washers must be facing the nut (Figure 8).
FIG. 2
FIG. 3
FIG. 4
FIG. 5
4. Lower the top half of the tool holder until it meets the handle of the hammer (Figure 9).
5. Re-place the lower half of the upper tool holder and screw it into place (Figure 9). This will secure the power tool; the tool can now be
plugged into the machine for operation.
6. Adjust the height as needed (Figure 10).
FIG. 6
FIG. 7
FIG. 8
FIG. 9
FIG. 10
