National Flooring Equipment DL2000, Operating & Service Manual

Page: 27 / 40

27
REPLACING THE FILTER
1. Turn off the dust collector by pressing the motor STOP buttons.
2. Disconnect the dust collector plug from the power socket.
WARNING: WeAR APPROPRIATe PeRSONAL PROTeCTION eQUIPMeNT.
3. Release the two retainers that hold the motor head in place. Lift the motor head and rest on a flat surface being careful not to damage
the power cable.
4. Remove the five retaining screws.
5. If the filter is stuck to the chamber, use a prying tool around the entire perimeter of the filter to loosen the filter from the chamber.
ATTENTION: Be CAReFUL NOT TO DAMAGe THe FILTeR OR CHAMBeR WHeN PRYING LOOSe THe FILTeR.
6. Remove the filter.
IMPORTANT! ALL THe MATeRIAL TRAPPeD BY THe FILTeR AND THe FILTeR ITSeLF MUST Be DISPOSeD OF THROUGH AUTHO-
RIZeD CHANNeLS IN THe COUNTRY WHeRe THe DUST COLLeCTOR IS USeD.
Maintenance
402539_DL2000_RevJ