Operation
FIG. 8
ACCESSORY ATTACHMENT
1. Tilt motor back to expose the underside of the machine.
2. Clean foreign material from magnet prior to tooling installation.
3. Place the individual tooling segments into two or four of the magnetic pockets. Be
careful around pinch points, as the tooling segments will snap into place as the
magnetic connection is made (Figure 8).
4. For safety, depending on the condition of the surface being prepared, the individual
tooling segments should be attached to the magnetic tooling holders using a single
mounting screw for each segment.
Note:
Use blanks in unused magnetic tooling pockets.
Attaching The Velcro Plate Adapter
The Velcro plate adapter attaches magnetically to the Magnetic tooling plate and snaps
into place (Figure 9).
Mounting Brazed Diamond and Polishing Pads
The brazed diamond and polishing pads are attached to the Velcro adapter plates (Fig-
ures 10; 11).
Mounting PCD’s
PCD’s are mounted to the holder (Figure 12) with tooling screws. The holder and PCD’s
are not magnetic, but are attached to the magnetic plates.
Note:
When setting the machine down into the operating position, hold the machine
firmly and set it down gently.
FIG. 10
FIG. 12
FIG. 11
10
FIG. 9
WARNING:
WHEN ACCESSORIES ARE EXPOSED, NEVER OPERATE
MACHINE. SERIOUS INJURY AND POSSIBLE PLATE DISENGAGEMENT COULD
OCCUR.
9241
Assembly
9245
Adapter
TOOL HOLDER & VELCRO ADAPTER
CAUTION:
DAMAGE TO ACCESSORIES AND MACHINE COULD OCCUR IF
DROPPED.
