Maintenance
9
WHEEL REMOVAL
([DPLQHEDFNRIZKHHOVWRVHHLIGHEULVLVEXLOWXS8VHDÀDVKOLJKWLIQHHGHG
2. Unplug machine; lay it on its side.
4. Use 5 mm Hex wrench to remove wheel securing screw (Figure 8).
6. Remove wheel securing cap; wheel will slide off. Watch for keyway key.
8. Remove wheel spacer. This should be inspected at regular intervals.
ADDING/CHANGING HYDRAULIC FLUID
•
&KDQJHRUDGGÀXLGZKHQQHHGHGDQGRUDWOHDVWRQFHD\HDUXQGHUQRUPDOFRQGL
-
WLRQV&KHFNÀXLGOHYHOLIWKHUHKDVEHHQDOHDNGDPDJHGRUUXSWXUHGKRVHRUD
ORRVH¿WWLQJ)OXLGVKRXOGEHOHYHOZLWKERWWRPRIWDQNSOXJKROH)LJXUH
•
7RDGGÁXLG
XQVFUHZ¿OOHUSRUWFDSIURPWRSRIPDFKLQH)LJXUH
•
7RFKDQJHÁXLG
UHPRYH¿OOHUSRUWFDS5HPRYHGUDLQSOXJIURPVLGHRIPDFKLQH
)LJXUH$QOLWHUFRQWDLQHUZLOOEHQHHGHGWRGUDLQÀXLGLQWRÀXLGZLOOQRWEH
removed from hoses).
•
0DFKLQHKDVDVWUDLQLQJV\VWHPEXWDGGÀXLGWKURXJKD¿OWHURUIXQQHOZLWKD
VFUHHQWRNHHSÀXLGFOHDQ
INSPECTION OF INTERNAL PARTS
Visual inspection of internal parts can be done without draining tank.
1. Remove two lifting bail eyebolts and the two bolts from the back of the tank.
2. Carefully lift tank 3-4”.
8VLQJDÀDVKOLJKWLQVSHFWWKHGULYHFKDLQKRVHVIURQWVHDORQPRWRUDQGVXFWLRQ
and pressure line on pump.
4. If service is necessary, follow procedure for tank removal.
TANK REMOVAL
Removing the tank is necessary to repair the pump or replace or service internal hoses.
)ROORZSURFHGXUHWRFKDQJHÀXLGLQRUGHUWRGUDLQWKHWDQN
5HSODFHGUDLQSOXJDQG¿OOHUSRUWFDS
3. Remove two lifting bail eyebolts and the two bolts from the back of the tank.
4. Disconnect return line on back of tank, carefully lift tank 3-4” (7.6-10 cm) and dis-
connect suction line. Tank can now be removed.
FIG. 8
FIG. 9
FIG. 10
WARNING:
ALWAYS UNPLUG MACHINE BEFORE PERFORMING MAINTE-
NANCE.
Tank
Plug Hole
FIG. 11
Drain
Plug
Filler Port
Cap
Filler Port
Cap
Drain
Plug
