Machine Operation
RAMP UNLOADING
1. Position ramp securely to back of vehicle, making sure there is good contact (See
Figure D).
2. Position machine at the back of the truck in line with the ramp (See Figure E).
3. Carefully move machine onto ramp leaving cutting head down (in contact with ramp
surface). CAUTION: Machine even without weights weighs 264 pounds (119.75
kg). Make sure you have machine under control. Failure to do so could cause
machine runaway, damage to machine, damage to property or cause serious injury.
4. Slowly back machine down ramp (See Figure F).
OPERATING CONTROLS
MACHINE START-UP PROCEDURE:
1. Machine MUST be off before plugging machine into power source.
2. Plug machine into outlet.
3. Turn speed control to slowest position.
4. Push “ON/OFF” switch to the ON position.
5. Compress handle switch to move forward.
6. Control speed by varying amount of twist on handgrips.
SPEED CONTROL
•
Speed control knob can be adjusted while machine is running.
• Turning speed control knob counter clockwise will increase maximum forward
speed (See Figure G).
•
Turning speed control knob clockwise will decrease maximum forward speed (See
Figure G).
FIG. D
FIG. E
FIG. F
Fax: 763-535-8255
10
FIG. G
FASTER
SLOWER
Summary of Contents for 5280-AUS
Page 32: ......
