WIRE HARNESS INSTALLATION-
MOTOR CONNECTOR AND FLUID HOSE
5. Find the Motor Quick Connector section (d) of the
Wire Harness and thread it through the 3/4" hole cut
into the vehicle’s body. Pull entire motor connector sec-
tion of harness through the hole.
Figure 9, 10
6. Use Rubber Grommet (e), attached to the wire har-
ness to plug the hole.
Figure 9
WIRE HARNESS INSTALLATION-
ROCKER SWITCH TO DASH
1. Locate the section of Wire Harness (c) that terminates
in the Two-Way Rocker Switch. Temporarily remove the
Rocker Switch and thread the wiring under the hood to-
ward the hole you cut in the dash panel’s accessory bay
in Figure 1. Thread the Wire End (c) through the hole.
Figure 12
National Cycle, Inc.
PO Box 158, Maywood, IL 60153-0158
P. 708-343-0400 / F. 708-343-0625 / E. [email protected]
www.nationalcycle.com
©2015 National Cycle, Inc.
Page 5 of 12
10-118025-000 04/15
Figure 9
Figure 10
Figure 11
Figure 12
