Page 2 of 2
10-110736 Rev.B 07/02
MAINTENANCE
©1999 National Cycle, Inc. PO Box 158, Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e mail: [email protected]
1. HORIZONTAL AIM
A. To adjust the Spotlights or Turnsignals right or left
gently rotate the lamp into the correct position. In the event
that the lamps become loose, refer to the procedure for verti-
cal adjustment.
2. VERTICAL AIM
(In addition to the tools needed for installation)
Hex Key, 5/32" or 4mm
Deep Socket and Socket ; 9/16" or 14mm
A.
Disconnect wire connections inside the Headlight Shell.
B.
Pull the wires out of the Light Bar tube.
C.
Turn the Turnsignal to provide access to the mounting
screws.
D.
Unscrew the Turnsignal mounting screws and remove the
Turnsignal (Hex Key).
The high quality chrome finish of your National Cycle
light bar can be maintained with any quality chrome
cleaner and /or polish.
Replacement bulbs and bulbs for the Turnsignals can
be found at motorcycle and accessory dealers as
well as automobile parts stores.
TESTING
ADJUSTMENT
1. Check all lights for proper operation.
2. Check the tightness of all fasteners that have been
involved in this installation
E.
Push the Spotlight wire up into the Spotlight
Shell.
F.
Loosen the nut on the Spotlight stud (Deep
Socket).
G.
Now, adjust the Spotlight. Reconnect the spot-
light wire and illuminate to verify its projection.
H.
Push wire into the Spotlight Shell.
I.
Firmly retighten the nut on the Spotlight stud.
J.
Pull the wire out of the Spotlight Shell.
K.
Reassemble in reverse order of disassem-
bly.
L.
Adjust the Spotlights and Turnsignals hori-
zontally by rotating into position.
M.
Verify operation of the lights.
