9
Important Operating Instructions
4.
Start the air compressor and set the regulator to needed pressure.
Do not exceed maximum air pressure.
5.
Test the consistency by spraying on a piece of scrap material.
If it appears too thick, add a very small amount of thinner (not included) and mix
thoroughly. Use the proper thinner for the type of paint.
Thin CAUTIOUSLY
. Proceed
slowly, adding minimal amounts at a time.
Do not exceed the manufacturer’s thinning recommendations.
Fan Direction
1.
To change the direction of the fan from
horizontal to vertical, loosen the lock ring
and turn the nozzle 90°.
2.
After the adjustment, tighten the lock ring
by hand.
Pattern Adjustment
WARNING:
Do not exceed the maximum
air pressure.
1.
Adjust the air supply pressure during
operation with the trigger fully depressed
and the air knob fully open.
If reducing air pressure for specific areas,
use the air knob.
2.
Use the pattern adjustment knob to
adjust the spray pattern. Turn pattern
adjustment knob counterclockwise (all the
way open) to flatten the spray pattern. Turn
it clockwise for a round spray pattern.
Fan Direction
Pattern Adjustment
