24 - EOLIS Air Manager 600 600S 1200 1200S
EN
“Plan to change filter block
(leave the device switched
on during replacement and
confirm the message before
closing the front cover)”
Your filter block are reaching saturation (80%) and must be changed
quickly (think about ordering filter block in advance from your dealer).
“Door open”
If the front cover/door of the device is not shut correctly, the unit will not
operate correctly. Make sure to close the cover correctly.
“Cover open. New filter block?” When you open the front cover, your air purifier may ask you if you have
changed the filter block. If so, you can confirm, and if not, press on the cross.
“Cover open. Sensor cleaning?”
When you open the front cover, your air purifier may ask you if you have
cleaned the sensors (only if sensor cleaning was required). If so, you can
confirm, and if not, press on the cross.
“Pending filter block change
(leave the device switched
on during replacement and
confirm the message before
closing the front cover)»
Your filter block are 100% saturated. Your unit needs new filter block to
operate correctly. Change the filter block and turn the unit back on.
«Clean sensors (leave the device
switched on during cleaning
and confirm the message before
closing the front cover)»
The PM2.5 and VOC sensors require regular maintenance (see p.22 to 23)
«Treatment in progress but not
optimised. Contact your local
retailer»
EOLIS Air Manager might be too small for your room’s surface area.
Also make sure that no exterior doors or windows are open.
“Active oxygen treatment for 1
hour. Leave the room. Starting
in 30s”
When you activate Active oxygen Mode 2, you must leave the room for 1
hour. Once mode 2 is activated, you have 30 sec to leave the room.
“Active oxygen treatment for 1
hour. Leave the room. End in X min”
When you activate Active oxygen Mode 2, you must leave the room for
1 hour.
“Temperature sensor out of
order”
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
“VOC sensor out of order”
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
“Particle sensor out of order”
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
“Pressure sensor out of order”
If this message appears in the Errors category, make sure your unit is
plugged in or contact your dealer.
“Smart noise activated”
(Only in ACTIVE mode)
EOLIS Air Manager has detected a high level of pollution. If after 30 min,
the level of pollution remains, your air purifier will go down to a lower
speed to not be too loud, and then will operate at a higher speed again
when required by the air quality.
- Make sure that the doors and windows are closed correctly
- Make sure that your device is not too small (placed in a room larger
than one it can purify)
“Ventilator jammed or no filer”
If the filter block is missing, put it back in the unit. If the filter block is in
the unit, please contact your dealer.
“UV-C lamp out of order”
This message appears when one or both UV-C lamps are no longer
working. Simply replace the defective lamp(s).
24 - EOLIS Air Manager 600 600S 1200 1200S
EN
