Page 4
Natcomm
INSTALLATION
WITH NATCOMM DEVICE Cont…
WHEN USING WITH A NATCOMM DEVICE
1.
Connect your Natcomm switching device to the ‘Relay Input’
socket of
Tone Alert.
2.
Connect the 3.5mm ‘Audio Out’ port of
Tone Alert
to an external
speaker or amplifier – if required, for increased volume
3.
Connect the power supply of the Natcomm switching device to the
switching device and turn power on. The LED on the Natcomm
switching device and
Tone Alert
should both display green
4.
When the switching device is activated
Tone Alert
will emit an
Alert Tone
5.
The tone that is emitted can be adjusted to suit your requirements
as follows by using the dip switches on the underneath side:
i. Change the Frequency of the Alert Tone
ii. Change the Cadence of the Alert Tone
iii. Refer to page 7 for Dip Switch Settings
6.
External power supply for
Tone Alert
is only required if the
Natcomm switching device and the
Tone Alert
are in excess of
100m apart from each other
NOTE:
Dip Switch is an optional extra that must be requested when
ordering.
