Page 18
Natcomm
PROGRAMMING OPTIONS
DS2 is pre-programmed with the most commonly used settings. In most cases,
you will not need to change any settings, with the exception of Entering the
Dial Out Number.
However, a number of settings can be changed to allow you to customize DS2
to meet individual requirements. DS2 will retain your settings even if power is
disconnected.
DOOR PHONE CALL ADVICE TONES
5 shorts ‘beeps’ can be injected into the Door Phone call, immediately after answer, to
advise you that the incoming call has originated from your Door Phone. This facility is
very useful for those users who may use cordless phones that do not ring differently
when there is a Door Phone call.
Allowable Range
:
ON or OFF
Default Setting is
:
OFF
NUMBER OF RINGS before stopping or initiating Dial Out
DS2 will ring your telephones 10 times when it is triggered by a Door Phone call. This
can be changed from 1-99 rings. DS2 has the ability to DIAL OUT to an external
telephone number or mobile number, if the call is unanswered after the programmed
NUMBER OF RINGS.
Allowable Range
:
1 to 99 rings
Default Setting is
:
10 rings
LOCK TIME OUT
The Lock relay control facility is used to open a gate or lock. You can set the time
which the LOCK will remain open after the user presses the ** command, to between
01-99 seconds. This is the time interval that the LOCK REMAINS OPEN after
pressing **
Allowable Range
:
01 to 99
Default Setting is
:
10