NatComm DS-SIP, User Manual

Page: 6 / 20

Page 6 Natcomm
SIP INSTALLATION
A Windows based program (called Natcomm SIP Controller) is supplied for
your
DS-SIP unit. This program is designed for use on PC running Windows 7
or later (on your same network). Install the program by double clicking the
supplied Program file. The program will install and a Natcomm Icon will be
installed on the desktop.
Connect DS-SIP to the Network
Using the supplied CAT5 cable connect the NETWORK port of
DS-SIP to your
Internet Network, at a convenient Network Point or direct to a Switch or
Modem-Router. Connect the Supplied Power Adaptor and Switch the Power
ON.
Wait 1-2 minutes while DS-SIP ‘bots up’ and registers to your Network
Double Click the Icon to open the program. Once the program has loaded,
Click for IP Address
After a short delay, the
program will then display the IP
Address, Gateway Address
and Subnet Mask of
DS-SIP.
The Password is : root
Enter the Password and then Click Login to Enter the Advanced
Settings area. This is where you can set up the SIP settings of the device.
SIP Parameter Setup
Refer to pages 17-20 for all SIP set up instructions).
A) Setting up the Extension Number
B) Setting Up a Username and Password
C) Setting Up the Network Server IP address
D) Changing from DHCP to Static IP
E) Changing the Speaker Volume of the Intercom connected to DS-SIP
F) Changing the Microphone Volume of the Intercom connected to DS-SIP
G) Load all Changes into the Internal ATA
H) Downloading the ATA User Guide for full ATA setting details.
5
4
(
1
2
3
4
5
6