3
INTERNAL STRUCTURE
•
Simulator bladder
•
Simulated mucosal folds
•
Simulated bulbous urethra
•
Simulated internal urethral sphincter
SET UP
A. To fill the Simulated Bladder
1.
Hang the fluid administration set 18" above the simulator. Use Fluid Supply Stand
(LF01022U shown, sold separately) or similar device.
Note:
Hanging the fluid administration set higher increases the water pressure and may
cause leaking.
2.
Close the slide clamp on the tube of the fluid administration set.
3.
Squeeze open the top of the bag and fill with water. (To extend the useful life of your
simulator, Nasco recommends distilled water.)
4.
Close the pinch clamp on the drain tube from the Male Catheterization Simulator.
5.
Connect the quick disconnect fittings of the administration set and simulator tubing.
(See Figure 1.)
6.
Open the slide clamp on the administration unit and the pinch clamp on the simulator
drain tube.
7.
Allow water to flow through the simulator until it exits the drain tube. Close pinch
clamp.
(See Figure 2.)
The system is now filled with water and pressurized.
Figure 2
Figure 1
INTERNAL STRUCTURE
•
Simulator bladder
•
Simulated mucosal folds
•
Simulated bulbous urethra
•
Simulated internal urethral sphincter
SET UP
A. To fill the Simulated Bladder
1.
Hang the fluid administration set 18" above the simulator. Use Fluid Supply Stand
(LF01022U shown, sold separately) or similar device.
Note:
Hanging the fluid administration set higher increases the water pressure and may
cause leaking.
2.
Close the slide clamp on the tube of the fluid administration set.
3.
Squeeze open the top of the bag and fill with water. (To extend the useful life of your
simulator, Nasco recommends distilled water.)
4.
Close the pinch clamp on the drain tube from the Male Catheterization Simulator.
5.
Connect the quick disconnect fittings of the administration set and simulator tubing.
(See Figure 1.)
6.
Open the slide clamp on the administration unit and the pinch clamp on the simulator
drain tube.
7.
Allow water to flow through the simulator until it exits the drain tube. Close pinch
clamp.
(See Figure 2.)
The system is now filled with water and pressurized.
Figure 2
Figure 1
3
HC190001INM19.indd 5-6
2/22/19 3:10 PM
