5
simulator doesn’t have the standard snap connectors. (Please
see accessories at the end of this section).
Once your manikin is connected to your patient simulator,
you will be able to pick up the ECG waves either through
the monitor hook-ups on the skin or through the two disks
attached to the skin on the defibrillation sites.
These disks will enable you to pick up the ECG waves using
either the “Quick Look” paddle option or directly through gel
pads, just like on a realpatient.
It is possible to use AED gel pads with the cable connectors
built into the gel — the same ones you use on patients.
In an effort to help you save money, Nasco offers a set of
training buttons that will correspond to your particular AED
unit. These buttons are sold separately, and can be used over
and over again. They come as a set with the patient
simulator adapters.
Set up
2
Available Supplies
LF03631U Replacement Headskin
with Airway
LF03627U Replacement Lung Set
LF03628U Replacement Stomach
LF03644U Pump Spray Lubricant
LF09919U Nasco Cleaner
Defibrillation Chest Skin
About the Simulator
The
Life
/
form
®
Child Defibrillation
Chest Skin has been designed for the
Child
CR
i
S
is
™
manikin to enable you,
the customer, to safely practice defi-
brillation.
The Child Defibrillation Chest Skin
has been designed to absorb a maxi-
mum of 360 joules of energy*.
Although capable of absorbing 360
joules, we recommend that the small-
est energy level possible be used
while training with the skin.
The Child Defibrillation Chest Skin will
enable you to practice defibrillation
using manual, semiautomatic, and
automatic external defibrillators
(AEDs). When using any one of these
types of defibrillators in training,
always follow the recommended
operating procedures for that particu-
lar defibrillator.
List of Components
• Defibrillation Chest Skin with
Load Box and Four Lead Snap
Cable Connector
*Note: 360 joules is the maximum
energy level that Nasco recommends
administering to the defibrillation
chest skin. Energy levels in excess of
360 joules may cause irreparable
damage to the chest skin, circuitry,
and patient simulator being used —
thus voiding Nasco’s warranty and
endangering your equipment. Nasco
assumes no liability for damage or
injury that may be caused by the use
and/or misuse of this equipment. All
normal safety precautions for defibril-
lation training should be followed, and
energy levels should be minimized.
Nasco did not design nor intend this
defibrillation chest skin to be used as
anything other than a training appara-
tus for defibrillation.
Connecting Your Patient Simulator
Connect the four lead snap cable to
your patient simulator.
Nasco has designed the Child
CR
i
S
is
™
System to be compatible with a vari-
ety of patient simulators. This is possi-
ble via the standard four lead snap
cable.
(See figure 2.) If your patient
simulator has only two output posts,
the red and black leads must be con-
nected to the patient simulator.
Figure 2
