RW-91 – Service Manual
Note:
18V/AC adapter is normally ordered separately
Connection:
- Put the printer on a table with enough space in front of it.
- Fit the rewinder in the front.
- Connect the Adapter with the cable from the 18V/AC input
plug on the rewinder control panel to the power mains socket.
- Let the ON/OFF switch stay in OFF position.
Adjustment:
- Load the paper stock and thread the paper web inside the
printer.
-
Make
sure
that
the
roll
and the web are properly inserted.
- Check carefully that it goes proper positioned along the
guide washer.
- Check the web is close to the gable.
-
Lower
the
printhead.
-
Switch
on
the
printer and Feed out a length of 40 cm of paper.
-
Insert
the
bobbin on the rewinder shaft.
- Stretch the paper again and move the bobbin support wing so
it becomes flush with inner side of the paper.
- For your information there is a friction clutch inside the rewinder.
-
This
friction
clutch
is
adjustable by a knurled disk for certain specific rare cases.
- However the rewinder is proper adjusted for all media that printer is designed
for.
- Use a full width paper core and insert it to the bobbin.
- Rewind manually a few turns so the paper is rewinded.
Note:
- The Bobbin has an adjustable plate. This plate can easily be moved by two
screws so it fits the paper core.
- Move always the plate so it is aligned with the bobbin.
- If not a paper core is used there is enough space beneath the plate to insert the
the web.
Printing &
- Set the ON/OFF switch in ON position.
Rewinding
- Start to print the labels.
