NASA electric NS-9096A, Instructions Manual

Page: 13 / 21

NS-9096A
Vacuum cleaner
8
Vacuum cleaner park mode
• Holding clamp is used to hold the tube,
flexible tube and main brush when the vac -
uum cleaner is in the horizontal position. )As
shown in Figure 6-1(
• If you do not use the vacuum cleaner and
keep it standing, use the park mode. To do this,
insert the main brush hook into the groove on
the back of the device body and press down
to secure it in place. )As shown in Figure 6-2(
Clean and maintenance guide
1.
Always turn off and unplug the appliance
before cleaning and storing it.
2.
To increase the life of the device and make
it more useful, it is better to always keep the
device clean.
3.
After finishing the work, you can move or
hold the vacuum cleaner vertically. Simply
insert the hook attached to the main brush
into the groove under the body of the vacuum
cleaner and press down to secure it in place.
4.
Clean the body of the device, pipes and
other parts of the device with a damp cloth
and then dry. Do not use solvents, alcohol,
thinners, etc. to clean the body.
5.
After use, insert the peripherals of the de -
vice into its place.
6.
Before assembling the power cord, make
sure that the cord is not damaged and do not
retract the wet power cord. Make sure the
power cord is completely dry before assem -
bling the power cord.
7.
For better performance of the device, its
longer life and use of after-sales service, use
only the accessories and main parts of the
device.
• Obtain parts and accessories from certified
NASA Electric dealerships or by visiting www.
nasaservice.com.
8.
Never use water to clean the hose, tele -
scopic tube and main brush. This can cause
them to rot, rust and damage.
Troubleshooting
Problem Possible cause Solution
• The device does not
turn on.
• The vacuum cleaner is off.
• The plug is not properly
connected to the electrical
outlet.
• There is a problem with
the power outlet.
• Connect the plug properly to the
electrical outlet.
• Turn on the device )turn the on / off
switch on.(
• Check the electrical outlet for
electrical connection and damage.
• Suction power
decreases over time.
• Suction power is low
or decreasing.
• The bag is full of dust.
• The main brush, hose
and telescopic tubes are
blocked.
• The filter is clogged with
dust .
• Empty the dust bag.
• Examine the main brush, hose and
telescopic tubes and remove any
blockages if they become clogged.
• Check the filter and replace or
clean it if necessary.
• The power cord does
not shrink.
• The power cable is out
of the winding path of the
collection.
• Pull the power cord slightly outward
and retract it. )By pulling the plug or
pushing the retractor switch(
6-1 6-2