31
Install the Photo Eye Safety System 1
、
Install the Safety
Reversing Sensors
The safety reversing sensors can be attached to the wall, The
sensors should be no more than 6 inches (15 cm) above the floor.
Position the mounting bracket against the wall with the curved arms
facing the door. Make sure there is enough clearance for the beam
to be unobstructed. Attach the mounting bracket to the wall using
lag screws.
Wire the Safety Reversing Sensors
Strip 7/16 inch (11 mm) of insulation from each set of wires.
Separate the wires. Twist the white wires together. Twist the
white/red wires together.
Summary of Contents for power 1000
