NARGESA MC 400-9, Instruction Book

Page: 8 / 18

MC400 BENDING MACHINE INSTRUCTION BOOK 6
3. INSTALLMENT AND STARTING UP
3.1.Instructions to set it up:
When the machine is put down by the crane it will be necessary to put it correctly so it doesn’t have to
be moved once it is on the floor. If it isn’t possible then it has to be put on a moveable base to move it
into a proper place.
The machine will be fixed by its own weight on the floor that’s why it has to be set on a flat surface.
3.2. Assembling to reduce noise and vibrations
This machine has a very low level of noise and vibrations, due to its low speed.
3.3. Instructions for the assembling and dismantling
The machine is transported completely assembled.
3.4. Admissible outer conditions
Environmental temperature Between: +5ºC and +40ºC without exceeding as average temperature
during 24h. Do not go beyond +35ºC. Humidity: Between 30% and 90% without water condensation.
3.5. Instructions to connect the machine to the power supply
It must be connected to only one power supply in the indicated power source. If the line tension is not
correct, then the engine bobins must be replaced.
It is very important to connect the machine properly to a groud socket
3.6. Safety systems for the user.
Never touch the rollers when they are bending material for the damage they can caus, there
might be risk of hands smashing.
The place to locate the machine must be selected taking into account the room it will occupy the metal
bar during the performance of the operation.