NARGESA 2021-1660, Instruction Book

Page: 14 / 40

- 16 -
You should keep in mind that this working mode will also allow the rod to descend bit by bit to adjust the
going down by the positioning of the lower end route. Whenever you keep the pedal pressed the rod will
make a descending movement that will be only interrupted when the route end is activated. When you raise
the foot off the pedal the rod will invert the movement and will start up ascending.
5.6. Meter deletion
As you have read in the previous sections, MX340G has got a punching meter that increases everytime
you press the pedal. This fact could be useful in case you need to count the punching operations required
for either a specific piece or the operations a third user has carried out with your machine.
Óbviously, this meter can be deleted. In order to do it right, and supposing there is a label like this one on
the LCD screen, for instance, You have carried out 150 punching operations, keep on the following indica-
tions.
Picture 18. Information about the number of operations made
.
It is important that the meter could be erased always and just when you find the machine ready to start wor-
king but without doing any operation (in StandBy mode it is not possible), so it is possible in Automatic or
Manual mode.
Just press the COUNTER key . Then the message in the screen will change into this other one.
Picture 19. Message of information about the meter deletion.
It is obvious that if you press ESC key , the meter will not be affected and it will go back to the previous
screen. On the other hand, in case you wish to delete the meter when you see the question made by the
previous screen, just press
COUNTER key again.the new message will show up as follows on the screen.
Figura 20. Information of the meter deletion
MANUAL
CNT: 150
Delete meter?
Meter deleted!