PACIFIC E27 – EG27
19 |
P a g e
PACIFIC E27 – EG27 Rev.00
Nardi Compressori – www.nardicompressori.com
7.03 OIL:
Oil is a very important component for the life of the compressor over time. Nardi Compressori has studied in detail the
compressor so that it has a large capacity oil sump and oil filter. A magnet has been fixed on the case to attract all
metallic impurities that settle at the bottom of the case.
Nardi Compressori recommends using our oil that has been designed and tested specifically for this machine. The
compressor is usually supplied with oil to be used only with non-mixed air (21% O²).
Oil Characteristics:
Low carbon deposit
No carbonizing effect
Good anticorrosive properties
Physiological and toxicological suitability
7.04 OIL CHANGE:
The steps for changing the oil of the compressor are as follows:
Make sure you have enough oil on hand to make the change.
Switch the compressor on for 15 - 20 minutes to heat the
oil and make it more fluid.
Remove the oil refill plug along with the oil breather extension.
Remove the oil drain plug and before opening the tap make
sure you have a container to catch the exhausted oil.
Close the tap and replace the oil drain plug.
Pour the new oil slowly down the oil filler neck.
Make sure that it reaches the maximum level (MAX).
Do not exceed this level.
Close the oil refill plug.
7.05 CHANGE TYPE OF OIL:
To avoid serious damage to the compressor when changing the type of oil, you must strictly follow the following steps:
• Follow the steps on the oil change Chapter 7.04.
• Change or clean all parts that have old oil.
• After 10 hours of operation of the compressor check if there is contamination.
• If the oil has been contaminated change it again.
• Do not mix different types of oil and always use the same type of oil.
