22
P R O G R AM M I N G U S E R C O D E S
Your Installer has programmed into your system a special User Program Code which can be used to not only Arm and Disarm
the system, but also to enter the User Program Mode, where you can program other User Codes. The following explains how
you will use this code to program or erase additional User Codes.
Entering the User Program Mode
1
Enter your User Code, then press
w
to enter the Function Mode.
2
Answer NO (press
"X"
or
q
) until "
17
" (Activate Program) is displayed, then press
YES ("
r
" or
p
).
The display will scroll "
P
" (Program mode); 4 digits identifying software versions; then "
UP
" (User Program). The keypad
sounder will beep while in the User Program Mode.
Programming / Reprogramming a User Code
1
Press
w
, followed by the the 2 digits of the user number to be programmed ( Example: for User 4, enter 04).
2
Press
w
, followed by the new User Code (up to 6 digits).
3
Press
w
repeatedly
until "
UP
" is displayed.
4
Press
u
to save the new User Code.
Note:
Duplicate Codes are not allowed; therefore a duplicate Code entered in the
LCD Window will erase when
u
is pressed. Repeat Steps 1 through 4 for each User Code to be programmed.
Erasing a User Code
To erase a User Code, press
w
, the 2-digit user number,
w
followed by
G0
until "
UP"
is displayed, then
u
.
•
Example: Erase User 3’s User Code:
Press
w03wG0G0G0G0G0G0
("UP" will display)
u
Reviewing a Programmed User Code
To review a User Code, press
w
,
the 2-digit user number and
w
to step through and review each digit of code.