Power
Turns the appliance ON/OFF.
Flame & Ember Light
Control
Heater Control
Timer
Temperature
Control
Controls Flame brightness and the Ember Light.
5 Settings: Flame & Ember off (FO), Ember on but Flame
off (LL), small Flame & Ember (F1), medium Flame &
Ember (F2), brightest Flame and Ember (F3).
Default setting is (F3).
Turns the Heater and Blower ON/OFF.
4 Settings: Heater & Blower off (HO), Blower on (BL), low
heat (H1), high heat (H2).
Default setting is (HO).
Timer can be programed to run appliance for specific
lengths of time (30mins. minimum to 6hrs maximum).
Default setting is Timer de-select.
Press and hold the Timer button for 5 seconds. This
will change the button to Temperature Control, or vice
versa. There are 7 temperature settings (61
°
F, 64
°
F, 70
°
F,
75
°
F, 81
°
F, 85
°
F and OFF).
Default setting is de-select Temperature Control.
F° / C° Switch
Hold 5
seconds
To change temperature format, Fahrenheit or Celsius.
Press and hold the Flame button for 5 seconds.
Default setting is Fahrenheit.
Heater Lock
Hold 5
seconds
Heater button can be locked or unlocked by holding the
Heater button for 5 seconds.
Default setting is heater unlock
Hold 5
seconds
EN
W415-1654 / E / 07.20.20
11
operating instructions
3.0 operating instructions
Once the log set has been plugged into a grounded electrical outlet or hard wired to a dedicated grounded 120V
power supply, it is ready to operate.
ATTENTION: Ensure the house circuit breakers for the power supply are turned on. When initially
connecting the appliance into a power source, the appliance will perfom an LED check. The appliance
will flash on and off for 5 seconds then remain off until turned on by control panel or remote.
The Control Panel is located on the front of the log set.
3.1 operating control panel
