1
. Turn off the electrical and gas supply to
the fi replace.
2
. Remove the frame from the unit by
removing the 2 black securing screws
from the top, and the 2 silver hex head
securing screws from the bottom. (FIG 1)
3
. Lay the frame down on its front, being
careful not to scratch the fi nish.
4
. Starting at the top of the frame, take
one light assembly and carefully snap it
into place in the hole provided. Repeat
for each of the light assemblies. The
wires on the top 2 light assemblies will
need to be fed in behind the heat shields.
Note: When installing the light kit be
careful not to scratch your fi ngers
on any of the exposed screws in the
frame.
5.
Using FIG 3 as a guide, connect the
light assemblies to the appropriate fl ags
on the wire harness. The wire harness is
labeled (TR) top right, (BR) bottom right
(TL) Top left and (BL) bottom left.
6.
Secure the wires into the clips at both
sides and the bottom of the frame. Use
the extra clips provided to retain any
loose wires.
7.
Re-attach frame onto unit.
8
. Remove the control panel by removing
the 2 screws securing it along the top
edge. Leave the wires connected to the
ON/OFF switch. (FIG 2)
9.
Place the transformer into the bottom
of the unit. Plug the transformer into the
receptacle.
10.
Lay the control panel fl at along the
bottom edge of the frame. Attach one
of the wire leads from the transformer
to the lead on the wire harness labeled
“TRANS”, and the other to the ON/OFF
switch. Attach the last lead on the wire
harness labeled “SWI” to the ON/OFF
switch.
11.
Re-secure the control panel.
12.
Turn on the gas supply and electrical
power.
LK8
(GT8) LIGHT KIT
INSTALLATION INSTRUCTIONS
W415-0670 / B / 10.19.11
Included with this kit:
Part #
Description
QTY
W010-1686 Assy, White LED
4
W707-0006 Transformer
1
W750-0187 Wire
Harness
1
W667-0014 Velcro
(Hook)
1
W667-0015 Velcro
(Loop)
1
W160-0095 Clip,
Wire
2
:ROI6WHHO/WG1DSROHRQ5G%DUULH21/0*&DQDGD ID[ ZZZQDSROHRQILUHSODFHVFRP
FIG 1
FIG 2
SWI
TRANS
TR
TL
BR
BL
FIG 3
CLIPS X5
