CLEARANCES FROM COMBUSTIBLES
Respect clearances as shown:
o
Sides of reflector : 60 cm
o
Above reflector : 45 cm
OPERATION
TO LIGHT
：
1.
From‘OFF’position, depress knob, turn 90° counter-
clockwise and hold.
2. Press the igniter until flame is established.
3. Release the knob and check that the flame stays lit.
4. If the flame goes out, wait 5 minutes then repeat steps
1 & 2 above.
5. For maximum temperature, turn knob fully counter–
clockwise.
TO TURN OFF
：
1. Turn the knob clockwise to the stop position.
2. Then depress knob and turn fully clockwise to completely
shut off the gas supply.
STORAGE
When heater is not in use for a prolonged period of time, remove
gas cylinder. Verify that the gas valve is closed tightly.
Do not store the gas cylinder indoors.
Store gas cylinder in a well ventilated area.
PREVENTIVE CARE AND MAINTENANCE
Once a year, the heater should be inspected for debris, insects, or spider webs that
could obstruct the burner. The burner area is likely to attract spiders. This may
damage the burner if it is not kept clean of debris.
HAVE HEATER INSPECTED IF ……..
●
You smell gas combined with yellow tipped flames on burner.
●
Heater does not provide expected heat capacity.
●
Burner makes little explosion sounds while operating.
This sound is normal when turning off the heater.
PRECAUTIONS
●
Verify periodically for leaks in the system, or immediately when you smell gas.
●
In case a leak is detected, put out all open flame in the area.
●
Never leak test while smoking.
