READ SAFETY REQUIREMENTS BEFORE
OPERATION
1. The installation must conform with local codes or in the absence of local codes, with either
the National Fuel Gad Code, ANSI Z223.1, or CSA B149.1, Propane Installation Code.
2. This outdoor gas appliance is not intended to be installed in or on recreational vehicles
and/or boats.
3. Maintain proper clearances from combustible construction top 45 CM, sides 60 CM.
4. Inspect the hose before each use of the outdoor gas appliance. If it is evident there is
excessive abrasion or wear, or the hose is cut, it must be replaced prior to this outdoor gas
appliance being put into operation. The replacement hose assembly must be that specified
by the manufacturer.
5. Properly locate the gas hose, keep out of pathways where people may trip over it or in areas
where the hose may be subject to accidental damage.
6. Maintenance Instruction
•
Keep outdoor gas appliance area clear and free from combustible materials, gasoline and
other flammable vapors and liquids.
•
Do not obstruct the flow of combustion and ventilation air.
•
Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.
•
Cleaning this outdoor gas appliance, including special surfaces, with recommended cleaning
agents, if necessary.
•
Check and clean burner tube to remove any insects and insect nests. Blocked burner tube
can lead to a fire.
•
Maintain adequate clearance around air openings into the combustion chamber, clearances
from combustible material. Air passages to the burner & combustion chamber must be open
and clear.
•
Certain materials or items, when stored under the appliance, will be subjected to radiant
head and could be seriously damaged.
WARNING:
1. Children and adults should be alerted to the hazards of high surface temperature
and should stay away to avoid burns or clothing ignitions.
2. Young children should be carefully supervised when they are in the area of the heater.
3. Clothing or other flammable materials should not be hung from the heater, or placed
on or near the heater.
4. Any guard or other protective device removed for servicing, the appliance must be
replaced prior to operating.
5. Installation and repair should be done by a qualified service person. The heater
should be inspected before use and at least annually by a qualified service person.
More frequent cleaning may be required as necessary. It is imperative that control
compartment, burners and circulating air passageway of the appliance be kept c
