7
www.napoleon.com
www.napoleon.com
N415-0580-AU REV - MAy 11.22
N415-0580-AU REV - MAy 11.22
Gas Hook-Up Instructions
WARNING!
A fire will result if the gas supply hose makes contact with the underside of the grill or
drip pan
.
Cylinder Installation:
Check that the cylinder valve is closed by turning the knob clockwise. Check that
the grill’s burner knobs are in the off position. Open cabinet doors. Set cylinder into hole in bottom
shelf.
Place the cylinder so that the valve faces toward the front of the grill. Other cylinders may be
acceptable provided they fit properly into the tank retaining ring.
Cylinder Connection POL
:
Do not attempt to use a cylinder, which is not equipped with a LCC27 type
connection. Do not use an adaptor at the cylinder connection.
Ensure the gas regulator hose is kink free.
Remove the cap or plug from the cylinder fuel valve. Insert the regulator onto the fuel valve. Hand tighten
clockwise. Do not use tools. Leak test all joints prior to using the grill.
A leak test must be performed
annually and each time a cylinder is hooked up or if a part of the gas system is replaced.
!
!
This gas grill is certified for outdoor use and should be installed in conformity with AS/NZS 5601 and local
codes. Check gas type and specifications located on the rating plate located on the back panel of the grill.
Universal Liquefied Petroleum Gas
Cylinder Specifications
WARNING!
If these instructions are not followed exactly, a fire causing death or serious injury may
occur.
WARNING!
Do not store a spare ULPG cylinder on the shelf beneath the barbecue.
This gas grill has been designed for use with an approved 9 kg size Universal Liquefied Petroleum Gas
cylinder (not supplied). The Universal Liquefied Petroleum Gas cylinder must be equipped with the
appropriate tank valve connection. Do not use an adaptor at the cylinder connection. A dented or rusty
cylinder may be hazardous and should be checked by your Universal Liquefied Petroleum Gas supplier.
Never use a cylinder with a damaged valve. The cylinder supply system must be arranged for vapor
withdrawal and the cylinder shall include a dust cap to protect the cylinder valve. The cylinder shall
incorporate a listed OPD (overfill protection device). Do not store a spare Universal Liquefied Petroleum
Gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent full.
