Napoleon PTH31GT, Manual

Page: 4 / 40

www.napoleongrills.com
4
EN
General Information
This gas torch is certified under Canadian and American national standards, CSA 2.37a – 2008 and ANSI
Z83.26a - 2008 respectively for outdoor patio heaters and must be installed to conform with local codes.
When an appliance is for connection to a fixed piping system, the installation must conform with local
codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Natural
Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2.
CALIFORNIA PROPOSITION 65 : The burning of gas fuel creates by-products, some of which are on the
list as substances known by the State of California to cause cancer or reproductive harm. When heating
with gas, always ensure adequate ventilation to the unit, to minimize exposure to such substances.
Propane Cylinder Specifications
WARNING!
If these instructions are not followed exactly, a fire causing death or serious injury
may occur.
A dented or rusty cylinder may be hazardous and should be checked by your propane supplier. Never use a
cylinder with a damaged valve. Use only a propane supply cylinder constructed and marked in accordance
with the specifications for LP-gas cylinders of the National Standard of Canada, CAN/CSA-B339, Cylinders,
Spheres and Tubes for Transportation of Dangerous Goods; and Commission, as applicable or the
Specifications for LP-Gas Cylinders of the U.S. Department of Transportation (D.O.T.). This appliance has
been designed for use with a 20 lb. (9.1 kg) or 30 lb (13.6 kg) size propane cylinder only (not supplied).
The propane cylinder must be provided with a cylinder connection device compatible with the connection
for outdoor gas appliances. The propane cylinder must be provided with a shut-off valve terminating
in a propane cylinder valve type QCC1, and a safety relief device having direct communication with the
vapor space of the cylinder. The cylinder supply system must be arranged for vapor withdrawal and the
cylinder shall include a collar to protect the cylinder valve. The cylinder shall incorporate a listed OPD
(overfill protection device). Do not store a spare LP-gas cylinder under or near this appliance. Never fill
the cylinder beyond 80 percent full.
Place the dust cap on the cylinder valve outlet whenever the cylinder is not in use. Only install the type of
dust cap on the cylinder valve that is provided with the cylinder valve. Other types of caps or plugs may
result in leakage of propane.
Use only the pressure regulator and hose assembly provided with this patio torch. Replacement pressure
regulators and hose assemblies must be specified by the manufacturer. Do not store a spare propane
cylinder on the shelf beneath the torch.
The regulator supplies a pressure of 11 inches. water column to the patio torch and has a QCC1 type
fitting. Cylinders to be used with this unit must be supplied with a QCC1 cylinder valve. A QCC1 cylinder
has a positive seating connection, which will not allow gas flow until a positive seal has been achieved. It is
also equipped with an excess flow device. In order to attain full flow to the torch, the valve must be in the
off position when the cylinder valve is turned on.
Gas Hook-Up Instructions
WARNING!
Installation and repair must be done by a qualified service person. The appliance must
be inspected before use and at least annually by a qualified service person. More frequent cleaning
may be required as necessary. It is imperative that the control compartment, burners and circulating air
passages of the torch be kept clean.