4
www.napoleongrills.com
General Information
This Gas Barbecue Is Certified Under Canadian And American National Standards,CSA 1.6-2007 and ANSI
Z21.58-2007 respectively for Outdoor Gas Grills and should be installed to conform with local codes. In
absence of local codes, install to the current CAN/CSA-B149.1 Propane Installation Code in Canada or to the
National Fuel Gas Code, ANSI Z223.1 in the United States.
If a rotisserie motor is used, it must be electrically grounded in accordance with local codes or, in absence of
local codes, with the current CSA C22.1 Canadian Electrical Code in Canada or the National Electrical Code,
ANSI/NFPA 70 in the United States.
California proposition 65
: The burning of gas fuel creates by-products, some of which are on the list as sub-
stances known by the State of California to cause cancer or reproductive harm. When cooking with gas, always
ensure adequate ventilation to the unit, to minimize exposure to such substances.
Propane Cylinder Specifications
WARNING!
If these instructions are not followed exactly, a fire causing death or serious injury may
occur.
A dented or rusty cylinder may be hazardous and should be checked by your propane supplier. Never use a
cylinder with a damaged valve. Use only a propane supply cylinder constructed and marked in accordance with
the specifications for LP-gas cylinders of the National Standard of Canada, CAN/CSA-b339, Cylinders, Spheres
and Tubes for Transportation of Dangerous Goods; and Commission, as applicable or the Specifications for LP-
Gas Cylinders of the U.S. Department of Transportation (D.O.T.). This appliance has been designed for use with
a 20 lb. (9.1 kg) size propane cylinder only (not supplied).
The propane cylinder must be provided with a cylinder connection device compatible with the connection for
outdoor cooking appliances. The propane cylinder must be provided with a shut-off valve terminating in a pro-
pane cylinder valve type QCC1, and a safety relief device having direct communication with the vapor space of
the cylinder. The cylinder supply system must be arranged for vapor withdrawal and the cylinder shall include
a collar to protect the cylinder valve. The cylinder shall incorporate a listed OPD (overfill protection device).
Do not store a spare LP-gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent full.
Use only the pressure regulator and hose assembly provided with this barbecue. Replacement pressure regula-
tors and hose assemblies must be specified by the manufacturer. Do not store a spare propane cylinder on the
shelf beneath the barbecue.
The regulator supplies a pressure of 11 inches. water column to the gas grill and has a QCC1 type fitting. Cyl-
inders to be used with this unit must be supplied with a QCC1 cylinder valve. A QCC1 cylinder has a positive
seating connection, which will not allow gas flow until a positive seal has been achieved. It is also equipped
with an excess flow device. In order to attain full flow to the grill, the valves must be in the off position when
the cylinder valve is turned on.
Gas Hook-Up Instructions
WARNING!
A fire will result if the gas supply hose makes contact with the underside of the grill or drip
pan.
Propane Cylinder Installation
: Set cylinder into hole in bottom shelf.
Cylinder Connection
: Ensure the gas regulator hose is kink free. Remove the cap or plug from the cylinder fuel
valve. Insert the black QCC1 regulator nipple onto the QCC1 fuel valve. Hand tighten clockwise. Do not use
tools. Leak test all joints prior to using the grill. A leak test must be performed annually and each time a cylin-
der is hooked up or if a part of the gas system is replaced.
If this grill is to be connected directly to a house propane gas supply line, follow the instructions for the natural
gas hook-up. Optional side burners must also follow the natural gas hook-up instructions. Note: The propane
tank heat shield is not required when the grill is connected to a fixed fuel supply, as its sole function is to shield
the propane tank normally used with the grill. Ensure that the supply pressure is 11 inches water column.
