EN
W415-1673 / A / 10.07.19
29
electrical information
A.
Remove the two screws that secure the junction box assembly to the wall mount plate and remove
the junction box assembly. The junction box assembly must be secured to the wall mount plate (as
illustrated).
B.
Route the supply wire through the 7/8” (22mm) hole of the junction box plate with a box connector
(not supplied).
C.
Connect the 120 volt supply wire to the receptacle as per the CSA C22.1 Canadian Electrical Code in
Canada or the ANSI/NFPA 70-1996 National Electrical Code in the United States.
D.
Once the wiring is complete, reinstall the junction box assembly by reversing step A making sure all
wires are secure in the junction box.
5.3
receptacle wiring diagram
If desired, the wiring from the junction box can be wired through the top and/or bottom knockouts
on the electrical housing box and run through the outlet on the outer left panel.
note:
