W415-1799 / B / 06.11.19
EN
26
maintenance
1. Remove the safety barrier and glass door (see
"safety barrier and door removal/installation"
section).
2. Remove burners (see "burner removal" section).
3. Remove the 2 screws holding the rear orifice
bracket in place, and then remove the rear orifice
bracket.
4. Remove the 6 screws holding the blower cover
plate in place, and then remove the blower cover
plate.
5. Remove the gasket and replace if necessary.
6. Remove the blower and replace if necessary.
6.8 night light™ replacement
6.7 blower replacement
Your appliance comes equipped with our “Night Light™”. The light has been pre-wired and is controlled from the
remote control.
If the lamp or lens needs to be replaced, follow the instructions
below.
A.
Unplug the appliance (the plug is located on the right side
of the appliance).
B.
Remove the 2 screws holding the light shield in place.
C.
Remove the 4 screws securing the lens frame
(Fig. 6-1)
.
This frame retains the glass lens. The lamp can now be
accessed.
The lamp will pull straight out of the socket. Replace with Wolf Steel parts only, as lamp
and lens are special “high temperature” products. When re-installing, ensure integrity of
gasket seal.
THE FIREBOX MUST BE SEALED.
Over-tightening the screws could break the lens. “Light Leakage” from the upper area
may be observed. The holes in the lamp housing are necessary for ventilation and must
not be covered.
GASKET
LENS
FRAME
COLOURED SIDE UP
JOINT
D’ÉTANCHÉITÉ
LENTILLE
CADRE
CÔTÉ COLORÉ
AU-DESSUS
Do not handle the lamp (bulb) with bare fingers.
Protect them with a clean, dry cloth.
note:
Fig. 6-1
Blower Cover
Plate
Rear Orifice
Bracket
