EN
W415-1719 / C / 04.07.17
15
operating instructions
• To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs,
bed, carriages or play pens. This bag is not a toy. Knot before throwing away.
!
WARNING
6.2 operating by remote control
When operating the remote control, it must be directed towards the front center of the log set.
note:
A.
The power button can be used to turn the log set on/off. Pressing
this button activates the power to the log set. Pressing the power
button again will turn off the log set. The ember and log will fade after
4 seconds after turning off the log set.
B.
To adjust the flame brightness and ember log light, press the flame
button . There is one ember log light and three flame brightness
levels to cycle through and then an off setting (LL, F1, F2, F3 and then
F0). F3 is the brightest flame level, LL is the ember log light only.
C.
To control the thermostat function press the thermostat button .
There are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F,
85°F and off). The default setting will display Fahrenheit. Press the
thermostat button to cycle through the settings. Once you have
selected the desired temperature the heater will automatically operate
until that temperature is reached. When the room temperature is 2
degrees lower than the temperature setting, the heater will turn on.
D.
To activate the heater and blower, press the heater button , the
blower will turn on. Press the heater button again to set desired low
or high heat temperature; press the heater button again to turn off the
heater.
E.
The timer controls all operating modes of the log set. To activate the
timer, press the timer button , the icon will illuminate and the time will
appear on the LED display. To choose the desired time, continue to
press the timer button, there are 8 settings (30mins,1h, 2h, 3h, 4h, 5h,
6h and off). The fireplace will turn off at the setting time.
F.
To turn off the log set, press the power button once on the remote, or press the power button once on the
control panel on the appliance.
This hand held remote control must remain within 6 meters or 19 feet of the log set to be effective.
note:
6.3 remote battery installation
1. To replace the existing battery, remote the battery
holder.
2. To remove the battery holder, turn remote onto front
side and press the left side lever towards the center
while pulling the battery holder out using the slot
provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into the
remote by sliding it into position, as shown.
4. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
REMOTE
(REAR SIDE)
BATTERY (CR 2025)
BATTERY COVER
